CNC lathe machining precision parts, how can we improve the quality of the product?

How to improve the quality of cnc lathe machining products workpiece?

1、Before carrying out machining center processing, please apply the calibrator to check whether the CNC blade is wobbling within the tolerated size tolerance. Before processing, you should apply a hot air gun to blow the blade and lock the nozzle neatly, or take a cloth to scrub to install the knife. Accuracy and health have certain hazards.

2, CNC lathe machining document flow chart specification should be normalized, including model specifications, name, program flow name, machining content, cnc insert specifications, cutting speed, especially the reliable length of the tool clamps, each program flow of pre-built capacity and its display light. Knife. To be clearly presented.

3, CNC lathe processing flow chart specification should be consistent with the reference angle orientation marked by the mold shell, and then check the 3D chart above, especially the product workpiece that has long been drilled to receive water, be sure to check whether the level on the 3D chart and the product workpiece is consistent.

4, before carrying out processing, must master the content of cnc CNC lathe processing program process, the program process must have 2D or 3D3d mapping, and must identify " X length, Y width, Z height " six-sided data information, in which to flat identification for " Z "value, convenient for the operator to check the program is appropriate after processing. When there are dimensional tolerances to mark the dimensional tolerance data information.

5, the reasonable use of cnc CNC lathe processing special tools, should be strictly different from stainless steel plate, copper male light knife processing, light knife redundancy should be effective, in order to make the smoothness of the product and the use of CNC blades into a very possible period. Stronger.

6, clamping, must pay attention to cnc cnc lathe processing product workpiece name and type specification and flow chart specification is not the same, raw material specifications are not paired, clamping relative height is not sufficiently high, and its application of the total number of calipers.

7, CNC lathe processing rate should be strictly controlled by the operator. f rate and s machine tool spindle rate should be effectively adjusted. F speed faster, should speed up the S machine tool spindle. The feed rate must be adjusted in different areas. After processing, check the quality is no problem, then you can get off and carry out a good processing.