How to solve the problem of abnormal speed for machining mechanical parts

In some parts manufacturers, we often encounter complicated problems. For example, the knife is off, the speed ratio is abnormal, the equipment produces noise, etc.. These problems, though minor, can be very dangerous if they are not handled properly. So how to solve the speed ratio problem when machining machine parts?

To solve this kind of problem, must have sufficient practical experience and outstanding technical, then what exactly is called speed ratio abnormal it, each manufacturer encountered the problem is likely to be not quite the same, for example, the machine equipment in the case of processing, will be in accordance with the raw materials of the parts configuration suitable speed ratio, assuming the pending 2000 rpm, the operation process up to a thousand rpm, until the case of query machine spindle The exhibit is not enough one thousand revolutions, many machines and equipment are going to face such a problem, this kind of just from two levels.

One, mechanical equipment parts processing to check the car gear problem, it is very likely that the high and low end data signal error, then such a thing to check the real speed than how much money, to establish the machine tool spindle speed ratio, based on the main parameters to carry out more, if the problem occurs in the serial communication machine tool spindle to words, such a thing is impossible to happen. Then there is another solution.

Second, in addition to the above methods, there is also a set of their own solution plan program, that is, in machinery and equipment parts processing to check the CNC machining core machine tool spindle main parameters, you can try to repair some reset machine tool spindle main parameters, and then try to try the machine tool spindle speed ratio, that can handle the good words, that the problem is in the main parameters on the side.